FAQ
For EX9000 Series
AIO Sampling rate list:
|
Please don’t calibrate before you really understand. Detailed see the EX9000 user manual.
I am text block. Click edit button to change this text. Lorem ipsum dolor sit amet, consectetur adipiscing elit. Ut elit tellus, luctus nec ullamcorper mattis, pulvinar dapibus leo.
For EX9188XD Series
1 UNDER HYPERTERMINAL OF PC.
2 POWER OFF THE EX-9188
3 PUT EX-9188END INT* PIN TO TOUCH ( CONNECT) GND.
4 POWER ON THE EX-9188 THEN RELEASE ( DISCONNECT) THE INIT * PIN TO GND.
5 UNDER HYPERTERMINAL TO THE IMAGE FILE :
TRNASFER —— SEND FILE——–PROTOCOL ( X MODEM) ———FILE NAME
——OK ( WITHIN 60 SEC) ( REFER User Manual, P10,P24,25,26,27).
6 THE SCREEN WULL SHOW CCCCCC. ……( WHEN TRANSFER FINISHED , EX-9188 WILL REBOOT AGAIN).
The INIT* pin must be disconnected right after executing uploading process.
Make sure click “transfer” at menu bar and choose the right function and file within 60sec after typing “xm /s” or “xm /r”. The transfer protocol must be “Xmodem”.
Open the cover and check the jumper5, 6 and 7. If pin 1 and 2 are connected, COM1 is RS232. If pin 2 and 3 are connected, it’s RS485.
For EX9188XD Series
1 UNDER HYPERTERMINAL OF PC.
2 POWER OFF THE EX-9188
3 PUT EX-9188END INT* PIN TO TOUCH ( CONNECT) GND.
4 POWER ON THE EX-9188 THEN RELEASE ( DISCONNECT) THE INIT * PIN TO GND.
5 UNDER HYPERTERMINAL TO THE IMAGE FILE :
TRNASFER —— SEND FILE——–PROTOCOL ( X MODEM) ———FILE NAME
——OK ( WITHIN 60 SEC) ( REFER User Manual, P10,P24,25,26,27).
6 THE SCREEN WULL SHOW CCCCCC. ……( WHEN TRANSFER FINISHED , EX-9188 WILL REBOOT AGAIN).
The INIT* pin must be disconnected right after executing uploading process.
Make sure click “transfer” at menu bar and choose the right function and file within 60sec after typing “xm /s” or “xm /r”. The transfer protocol must be “Xmodem”.
Open the cover and check the jumper5, 6 and 7. If pin 1 and 2 are connected, COM1 is RS232. If pin 2 and 3 are connected, it’s RS485.